No structure on the planet can be constructed 100% earthquake proof; only its resistance to earthquake can be increased. Treatment is required to be given depending on the zone in which the particular site is located. Earthquake occurred in the recent past have raised various issues and have forced us to think about the disaster management. It has become essential to think right from planning stage to completion stage of a structure to avoid failure or to minimize the loss of property. Not only this, once the earthquake has occurred and disaster has taken place; how to use the debris to construct economical houses using this waste material without affecting their structural stability.
HOW EARTHQUAKE RESISTANT CONSTRUCTION IS DIFFERENT?
Since the magnitude of a future earthquake and shaking intensity expected at a particular site cannot be estimated with a reasonable accuracy, the seismic forces are difficult to quantify for the purposes of design. Further, the actual forces that can be generated in the structure during an earthquake are very large and designing the structure to respond elastically against these forces make it too expensive.
Therefore, in the earthquake resistant design post yield inelastic behavior is usually relied upon to dissipate the input seismic energy. Thus the design forces of earthquakes may be only a fraction of maximum (probable) forces generated if the structure is to remain elastic during the earthquake. For instance, the design seismic for buildings may at times be as low as one tenths of the maximum elastic seismic force. Thus, the earthquake resistant construction and design does not aim to achieve a structure that will not get damaged in a strong earthquake having low probability of occurrence; it aims to have a structure that will perform appropriately and without collapse in the event of such a shaking.
Ductility is the capacity of the structure to undergo deformation beyond yield without loosing much of its load carrying capacity. Higher is the ductility of the structure; more
is the reduction possible in its design seismic force over what one gets for linear elastic response. Ensuring ductility in a structure is a major concern in a seismic construction.
Earthquake resistant building:
The engineers do not attempt to make earthquake proof buildings that will not get damaged even during the rare but strong earthquake; such buildings will be too robust and also too expensive. Instead, engineering intention is to make buildings earthquake resistant, such building resists the effects of ground shaking, although they may get damaged severely but would not collapse during the strong earthquake. Thus, safety of peoples and contents is assured in earthquake resistant buildings and thereby, a disaster is avoided. This is a major objective of seismic design codes through the world.
Earthquake design philosophy:
The earthquake design philosophy may be summarized as follows:
Under minor, but frequent shaking, the main members of the building that carry vertical and horizontal forces should not be damaged; however the building parts that do not carry load may sustain repairable damage.
Under moderate but occasional shaking, the main member may sustain repairable damage, but the other parts of the building may be damaged such that they may even have to be replaced after the earthquake.